About this Project

We were called out to a house that had a garage door that was completely off the track due to old worn out rollers and an older spring. 

We replaced the old rollers with nylon sealed bearing rollers and replaced the springs with the stronger high-cycle longer-lasting springs to properly counter balance the garage door properly.

About this Project

We were called out to a house that had a garage door with a broken garage door spring. After a quick inspection, we also realized that the garage door rollers needed to be replaced as well.

We replaced the springs first and then replaced the worn out plastic bushing rollers with nylon sealed bearing rolled (rated to last 100K cycles).

About this Project

Recently we fixed a customer’s broken Wayne Dalton TorqueMaster one piece spring line system and converted it to a standard high cycle spring line. The entire TorqueMaster needed to be replaced due to the springs being on the inside of the one part TorqueMaster spring line.

New high cycle springs rated for 10+ years of life will long outlast a new torq master as well as only needing new springs down the road when the replacement springs fail. All the other standard spring line components will be good to be reused optimizing the garage for future repairs.

About this Project

We helped our a customer that was referred to us by their neighbor with their broken spring. The door wouldn’t open due to one spring bein broken on this dual spring set up and roughly half the weight of the door was no longer being supported.

We replaced the springs so that the full weight of the door was supported as it should be and the door was back in working condition.

About this Project

We were called out to a customers home with their garage door that was completely dead weight. The single spring with old Windsor door springline was broken.

We converted it to standard springline, replaced worn cables, drums, new 17’ torsion shaft, spring anchor, and pair of high cycle springs.